Initial Server Conf...
 
Notifications
Clear all

Initial Server Configuration setup

6 Posts
2 Users
0 Likes
1,507 Views
Posts: 10
Topic starter
(@kuasha48)
Active Member
Joined: 6 years ago

Hi,

I just install SolidCP. Could anyone please tell me what will be the 1st server configuration setup?

Thanks in advance.

Fazla Rabby

5 Replies
Posts: 10
Topic starter
(@kuasha48)
Active Member
Joined: 6 years ago

Once I click the Server. I got this message "Error getting remote server information"

Reply
Posts: 1964
Admin
(@m-tiggelaar)
Noble Member
Joined: 8 years ago

Hello,

The initial configuration should have added the first server with some basic services on it.

since your getting "Error getting remote server information" most likely indicates that your bindings have not been set correct during setup.

I would open up IIS Management --> click the SolidCP Server --> on the right side check the bindings --> it should normally have one for 127.0.0.1:9003
which means in a web brower opening: http://127.0.0.1:9003 should display the SolidCP Server page.

You then go to the portal --> configuration --> servers --> yourservername Setting --> Connection settings at the top --> make sure it has the http://127.0.0.1:9003 set.

If it still doesn't work i would reset the Server password by going to start --> solidcp installer --> select the Server module --> settings --> at the end reset the password, then enter it in the portal connection settings.

Regards,

Marco

Reply
Posts: 10
Topic starter
(@kuasha48)
Active Member
Joined: 6 years ago

I uninstalled from the control panel for reinstall again. But I found 3 error when I tried to install again.

SolidCP Server Requirement (Windows account already exist: SCPServer)

SolidCP Enterprise Server Requirement and

SolidCP portal Requirement

 

Lots of thank you for your reply. Sorry, I made mistake already before your reply. 🙁

 

Thanks again

Md Fazla Rabby

Reply
Posts: 10
Topic starter
(@kuasha48)
Active Member
Joined: 6 years ago

Problem solved. I removed from IIS then install again.

Reply
Page 1 / 2
Share: