Forum

I don't think either way is "wrong" but in general I would prefer the less cluttered approach, especially for someone who uses a lot of subdomain webs...

I think the most recent one worked in command line without any changes. That one had apparently timed out in SolidCP (and displayed the Error.htm mess...

Thanks Trevor, that's interesting, especially since my second scheduled task has not been successful in getting everything to renew automatically. I ...

This problem sounds familiar to me. 🙂 Make sure the SolidCP Scheduler service is running. If you need to start it, check back a few minutes later t...

I think it helps to add something like the following to the system.webServer section of the LetsEncrypt Web_Config.xml file, and (if it doesn't cause ...

I think the first two issues are still the same in SolidCP 1.4.2 (and they are low priority). And as for the third, I think I found the reason I've h...

I checked the letsencrypt-win-simple scheduled task, and it was pointing to an old installation instead of the SolidCP one. I deleted the old task and...

I usually use Chrome on Windows 10. Just to clarify, I always get the prompt "Remove this item?" Sometimes it works, and sometimes not. This iss...

I tested one site and it appears to work. Note, SolidCP says my certificates are "not managed by SolidCP" which seems odd.

Same 0.0.0.0 issue here, on Windows 2012 web server. Sites are configured with "All Unassigned" IP address. I think it's a bug in letsencrypt-win-s...

I agree, the "Check to Enable Password Change" checkbox has been very confusing, and is still confusing in SolidCP 1.2.1. It has tripped me up several...

I would also appreciate a response to groulte's suggestions! I observe the same problem with the "Follow" button, so I cannot subscribe to any topic o...